about my hardware), let me know.Diff -git a//SCSIDrive.cs b//SCSIDrive.cs If you need any additional information (e.g. So, can anyone help me? What can I do to troubleshoot this problem? As I mentioned, I'm new to Linux, so I don't have any experience and I'm also not familiar with the different boot options (UEFI/BIOS et c.). My CPU is an Intel Xeon E3-1231 which has no built-in graphics unit, so I can't connect the monitors directly to the mainboard's VGA/DVI ports. ATAPI IHAS124 C USB Device driver download list Description: ATAPI IHAS124 C USB Device driver setup Version: 4.2.8 Date: Filesize: 0. The menues described above appeared on the one connected via DVI, while the other one got no signal. There is a new interface that will probably replace SATA (and SCSI SAS) within a few years. I have two monitors, one is connected via HDMI, the other via DVI, both to my GPU (MSI GTX 970 Gaming 4G). atapi ihas124 driver windows 10 full SATA and SCSI SAS are limited by the physical I/O architecture to a few thousand I/O commands per second. So I googled a bit and found this thread and pressed the ↓ key while the loading screen was visible, which gave me this menu:įollowing the instructions in the thread linked above, I tried setting the nomodeset option (and later the acpi=off and nolapic options as well), but still after I clicked Try Ubuntu without installing my monitor got no signal.

This time, I saw this loading screen:īut after a few seconds, it went away, I briefly saw the blinking vertical cursor and then some other text flash up on the upper left side of the screen, then got a black screen again (my monitor said no signal detected). (BTW, Windows is installed on an SSD which doesn't show up in this section at all, yet Windows starts up normally - curious) Future proof compatibility with the latest. In the Boot Priority section, there were three items in the following order: Support Features Higher transfer rates with SATA connection (compared to PATA). So I restarted again and entered the ASUS UEFI BIOS utility. Then I rebooted the computer, but it booted Windows again. I currently have Windows 10 installed and want to install Ubuntu as well (as dual-boot), so I shrinked one of the partitions of my hard-drive, downloaded Ubuntu 14.04.4 LTS from the Ubuntu-Website and burned the ISO on a DVD (using the Windows 10 tool via the context-menu → burn). So I wanted to try out Ubuntu (I have only worked with Windows so far), but all I get after the installation window is a black screen.

Atapi ihas124 windows 10 driver